REPLACEMENT TRI-COLORED GAUGE STICKS

ERL’s Tri-colored gauge sticks are designed and manufactured to provide extended service life. If the Gauge Stick becomes damaged, replacements are readily available. Simply provide the Serial No. of the old stick, which is located near the magnet housing at the base of the stick, or provide the Serial No. of the unit from the data tag on the unit flange.

Confirmation of the dimensions listed below and identified by the adjacent drawing are required if the replacement stick is being ordered for use in a non- ERL manufactured unit.

1. __________Overall length
2. __________Green Length
3. __________Yellow Length
4. __________Red Length
5. __________Top Gauge Marking Number
6. __________Diameter of magnet housing
7. __________Diameter of gauge rod
8. __________Guide Bushing diameter
9. __________(if non-ERL unit)

ERL’s DS-39 uses a standard Teflon guide bushing. When ordering and using ERL Tri-colored gauge sticks for use in non-ERL manufactured gauges be sure to include all the information requested. This information will be important if it is necessary for us to provide a new Teflon guide bushing sized to fit your unit.

Standard ERL Tri-colored gauge sticks perform well to 280°F. Prolonged use in temperatures higher than 280°F can cause the green, yellow and red colors to fade. For high temperature service specify our H.T. Series, high temperature gauge rods good for continuous service to 365°F.